Mitsubishi Electronics FR-S500 Output terminal function selection Pr. 64 , Pr, Setting

Terminal function selection parameters

2.9.2Output terminal function selection (Pr. 64 , Pr. 65 )

You can change the functions of the open collector output terminal and contact output terminal.

Parameter	Name	Factory	Setting Range	Remarks
		Setting
64	RUN terminal function	0	0, 1, 3, 4, 11 to
	selection		16, 93, 95, 98, 99	Setting is enabled
				when Pr. 30 = "1"
65	A, B, C terminal function	99	0, 1, 3, 4, 11 to
	selection		16, 95, 98, 99

<Setting>

Setting	Signal	Function	Operation	Parameters
	Name			Referred to
			Output during operation when the
0	RUN	Inverter running	inverter output frequency rises to	Pr. 2, Pr. 13
			or above the starting frequency.
1	SU	Up to frequency	Output when the output frequency	Pr. 41
			is reached.
3	OL	Overload alarm	Output while stall prevention	Pr. 21, Pr. 22,
			function is activated.	Pr. 23, Pr. 28
4	FU	Output frequency	Output when the output frequency	Pr. 42, Pr. 43
		detection	rises to or above the setting.
		Inverter operation	Output when the inverter is ready
11	RY		to be started by switching the	
		ready
			start signal on.
12	Y12	Output current	Output when the output current	Pr. 48, Pr. 49
		detection	rises to or above the setting.
13	Y13	Zero current detection	Output when the output current	Pr. 50, Pr. 51
			reaches 0.
14	FDN	PID lower limit	Outputs the detection signal
15	FUP	PID upper limit		Pr. 88 to Pr. 94
			under PID control.
16	RL	PID forward-reverse
		rotation output
			The output current average value
		Current average value	and maintenance timer value are
93	Y93		output during the constant speed	H3 to H5
		monitor signal	operation. (can be set to the RUN
			terminal (Pr.64) only)
		Maintenance timer	Output when maintenance
95	Y95		parameter H1 is greater than	H1, H2
		alarm
			maintenance parameter H2.
			Output when a minor fault (fan
98	LF	Minor fault output	failure or communication error	Pr. 76, n5
			warning) occurs.
			Output when the inverter's
99	ABC	Alarm output	protective function is activated to	
			stop the output (major fault).

REMARKS

One function can be assigned to two terminals.

100