Mitsubishi Electronics FR-S500 Maximum and minimum frequency settings, frequency jump

Specification list

					Maximum and minimum frequency settings, frequency jump
		Operational			operation, external thermal relay input selection, automatic
					restart after instantaneous power failure, forward/reverse
		functions
					rotation prevention, slip compensation, operation mode
specificationsControl
		signalsOutput			selection, PID control, computer link operation (RS-485).
					1 open collector signal can be selected from
					among inverter running, up-to-frequency,
					frequency detection, overload warning, zero	Use
					current detection, output current detection, PID
						Pr. 64 and
				Operating Status	upper limit, PID lower limit, PID forward/reverse
						Pr. 65 for
					rotation, operation ready, current average value
						selection
					monitor signal, maintenance timer alarm, minor
					failure and alarm. 1 contact output (1 contact, 230V
					0.3AAC, 30V 0.3ADC) signal can be selected.
				For meter	1 signal can be selected from between output frequency and
					motor current. Analog output (0 to 5VDC)
					Overcurrent shut-off (during acceleration, deceleration,
					constant speed), regenerative overvoltage shut-off (during
					acceleration, deceleration, constant speed), overload shut-
Protective/warning function					off (electronic thermal relay function), heatsink overheat, fan
					failure (*3), stall prevention, internal circuit error (*4), start-
					time output side ground fault protection (*5), external
					thermal relay (*6), disconnected PU, retry count over,
					communication error, CPU error, undervoltage (*1)
		Ambient			-10°C to +50°C (14°F to 122°F) (non-freezing)
		temperature
Environment		Ambient humidity			90%RH or less (non-condensing)
		Atmosphere			(without corrosive gas, flammable gas, oil mist, dust and dirt etc.)
		Storage			-20°C to +65°C (-4°F to 149°F)
		temperature (*7)
					Indoors
		Altitude, vibration			Maximum 1000m (3280.80feet) above seal level, 5.9m/s2 or
					less (conforms to JIS C 60068-2-6)
	*1. When undervoltage or instantaneous power failure occurs, no alarm output is provided but
			the output is shut off. After power restoration, the inverter may be run as it is. Depending on
			the running status (e.g. load magnitude), however, overcurrent, regenerative overvoltage or
			other protection may be activated at power restoration. (in the external operation mode)
	*2. The braking torque indicated is a short-duration average torque (which varies with motor
			loss) when the motor alone is decelerated from 60Hz in the shortest time and is not a
			continuous regenerative torque. When the motor is decelerated from the frequency higher
			than the base frequency, the average deceleration torque will reduce. Since the inverter
			does not contain a brake resistor, use an optional brake unit (BU) when regenerative energy
			is large.
	*3. Compatible with only the product having the built-in cooling fan.
	*4. Available for the FR-S520E-0.4K to 3.7K-NA only.
	*5. Activated only when "1" is set in Pr. 40 "start-time ground fault detection selection".
	*6. Activated only when external thermal relay input (OH) is selected in any of Pr. 60 to Pr. 63
			(input terminal function selection).
	*7. Temperature applicable for a short period such as transportation.

174