Mitsubishi Electronics FR-S500 Display function parameters, Monitor display Pr , Pr

Display function parameters

2.6 Display function parameters

2.6.1Monitor display (Pr. 52 , Pr. 54 )

You can choose the display of the operation panel "monitor/frequency setting screen".

Parameter	Name	Factory	Setting		Remarks
		Setting	Range
	Operation panel
52	display data	0	0, 1,	100
	selection				Setting is enabled when Pr. 30 = "1"
54	AM terminal function	0	0,	1
	selection

POINT

•You can also use the SET to change the display. (Refer to the instruction manual

(basic) for the operation procedure.)

•The analog voltage output terminal AM is available for signal output. (Make selection using the Pr. 54 "AM terminal function selection" value.)

<Setting>

		Parameter Setting		Full-Scale Value of AM
Signal Type	Unit	Pr. 52	Pr. 54
		Operation panel	AM terminal	Level Meter
		LED
Output frequency	Hz	0/100	0	Pr. 55 "frequency monitoring
				reference"
Output current	A	1	1	Pr. 56 "current monitoring
				reference"

When "100" is set in Pr. 52, the monitored values during stop and during operation differ as indicated below.

	0	Pr. 52	100
	During running/stop	During stop	During running
Output frequency	Output frequency	Set frequency	Output frequency
REMARKS

•During an error, its definition appears.

•During reset, the values displayed are the same as during a stop.

•For selection of the parameter unit (FR-PU04) monitor display, refer to the communication parameter n16 "PU main display screen data selection". (Page 152)

CAUTION

The unit displayed on the operation panel is only A and other units are not displayed.

♦Related parameters♦

•Speed display ⇒ Pr. 37 "speed display" (refer to page 81)

•Adjustment of AM level meter full-scale value ⇒ Calibration parameter C1 "AM terminal calibration" (refer to page 126)

•Monitoring reference ⇒Pr. 55 "frequency monitoring reference", Pr. 56 "current monitoring reference" (refer to page 92)

90