3-3
Installing the Driver
4Click Create Driver Disk, then select the appropriate operating
system.
5If you selected Linux, you need to also select the architecture, one
of the following:
–i386—For Intel 386 or 486 computers
–i586—For Pentium I or II computers
–i686—For Pentium III, IV, or AMD K-6 computers
–Athlon—AMD Athlon computers
6Select the appropriate floppy drive letter, then choose the
appropriate format. You need a full format only if the disk has
never been formatted or may have bad sectors.
7Insert a floppy disk, then click OK. The system creates the
driver disk.
8Remove and label the driver disk.
Now that you have created your driver disk, identify the appropriate
driver installation procedure and proceed with the installation.
Installing the Windows Driver
This section contains the following procedures:
■Installing the Driver When You Install Windows
■Installing the Driver in an Existing Windows System

Installing the Driver When You Install Windows

To install the driver with the operating system during a fresh
install:
1Install and configure the controller and hard drives, as
described in page 2-3.
2Create the bootable array, as described on page 2-4.
3Create the driver disk, as described on page 3-2. When finished,
remove the driver disk.
4Insert the Windows setup CD and restart the computer to begin
the Windows installation.