3-8
Installing the Driver
UnixWare and OpenUNIX
This section contains the following procedures:
■Installing the Driver When You Install UnixWare or OpenUNIX
■
Installing the Driver in an Existing UnixWare or OpenUNIX System
Note: Although the driver disk you create for UnixWare and
OpenUNIX differ, the installation procedures for these
operating systems are the same.
Installing the Driver When You Install UnixWare or OpenUNIX
To install the driver with the operating system during a fresh
install:
1Install and configure the controller and hard drives, as
described in page 2-3.
2Create the bootable array, as described on page 2-4.
3Create the driver disk, as described on page 3-2. When finished,
remove the driver disk.
4Insert the Unix installation CD and start the operating system
installation.
5When you see the prompt, Choose One, insert the driver disk,
select Install HBA diskette, and then pressF10.
The computer loads the driver from the driver disk, then the
HBA screen is displayed.
6Select Proceed with Installation, then press F10.
7Complete the installation as appropriate.
8When the installation is finished, remove the driver disk and
restart the computer.
Installing the Driver in an Existing UnixWare or OpenUNIX System
To install the driver in an existing operating system:
1Shut down the computer. Install and configure the controller
and hard drives, as described in Chapter2.
2Create the driver disk, as described on page 3-2. When finished,
remove the driver disk.