3-4
Installing the Driver
5When prompted to install a third-party driver, press F6.
Note: When F6 is active, a prompt appears at the bottom of
the screen for only 5 seconds. If you miss your chance to
press F6, restart the computer.
6Insert the driver floppy disk and wait until prompted to install
a driver. Press S to specify that the driver is on the floppy disk,
then press Enter. The computer reads the disk.
7When the Adaptec driver is found, press Enter. Respond to the
on-screen instructions to complete the installation.
Installing the Driver in an Existing Windows System
To install the driver in an existing operating system:
1Install and configure the controller and hard drives, as
described in Chapter2.
2Create the driver disk, as described on page 3-2. When finished,
remove the driver disk.
3Start Windows. Windows launches the Found New Hardware
Wizard, which searches for the driver.
4Insert the driver floppy disk, select the floppy drive as the
source, then click Next.
5Click Next in the two subsequent windows and follow the
on-screen instructions to complete the driver installation.
6Remove the driver disk and restart the computer.