Administrative Tasks
3-28 Initial Configuration 601354 Rev A
After media class migration starts, migration continues until
one of the following occur:
• The media class fill level reaches the media class low mark.
• The AO removes the media from the Eject list. Such media
enter the intransit state.
There are two reasons for removing such media from the source
archive Eject list. One is that the destination archive media fill
level may reach the destination archive high mark when media
are entered as a result of migration. If media are entered into the
destination archive and its high mark is exceeded, media type
migration begins for that archive (unless the destination
archive’s action mode migrate option is not selected).
Another reason to remove media from the source archive eject
list is when the destination archive media class fill level reaches
the destination archive media class high mark. Otherwise,
media class migration from the destination archive to some
other archive may be triggered. No media are accepted by the
destination archive media class when its absolute capacity is
reached.
Note that the archive media class high mark and low mark are
used to determine when to start and halt media class migration.
These marks apply only to an archive media class fill level and
is designated during archive media class creation.
Note
No media are accepted by the destination archive when its
absolute capacity is reached.
Note
No media are accepted by the destination archive when the
destination media class capacity is reached.