WALK TEST ? COMMAND 44
Walk Test
Description
Use this function to test command centers, detection devices, and sounders (both interior and exterior) to be certain they function properly. You can review untested points at your command center to help
You cannot arm your system while in the walk test mode, and no alarm reports are sent to your security company unless a
Upon initiation, the walk test will test the burglary bell pattern on the bell output and ring the command center burglary bell for 2 seconds. The AC will be disabled for 4 minutes in order to test the system’s battery power. If the battery cannot maintain the system for the 4 minute period, the command center will appear to go dead. If this happens, contact your security company. At the end of the 4 minute period, AC is returned to the system and the panel restores. To test individual
detection devices, simply activate sensors and open protected doors and windows
Using Walk Test:
1.Ensure your command center shows idle disarmed
text. | 44 |
|
2.Press the COMMAND bar. The display shows
SYSTEM COMMAND.
3.Press the 4 key, followed by the 4 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function. Press the MENU key to enter the Command Menu, then press NEXT repeatedly until you reach the WALK TEST ? prompt. Press ENT.