Document 50934 Rev B 5/15/00 PN 50934:B 33
Two phone numbers must be programmed, the Primary phone number and the
Secondary phone number. All system reports will be transmitted to the primary phone
number. Reports will automatically be sent to the secondary phone number if attempts
to transmit to the primary phone number are unsuccessful. If 10 total attempts to
communicate are unsuccessful, the Communicator Failure output will be turned on
(TB3, terminal 2). Note that as an option, all reports may also be sent to the
secondary phone number. Refer to Section 3.0 Programming Instructions.
The ADT-UDACT meets NFPA 72 for Remote Station Protective Signaling Service
and Central Station Signaling Service reporting requirements for: (a) the type of
signal (b) condition and (c) location of the reporting premises.
Since higher priority events take precedence over lower priority events, the ADT-
UDACT will transmit higher priority events before sending the lower priority events.
Priorities are as follows:
Event Activations
1. General Alarm
2. Zone/Point Alarm #N
3. General Supervisory
4. Zone/Point Supervisory #N
5. General System Trouble
6. AC Power Loss
7. Zone/Point Trouble #N
8. Low Battery
9. Telco Primary Line Fault
10. Telco Secondary Line Fault
11. NAC Fault Code
12. Communication Trouble, Primary Number
13. Communication Trouble, Secondary Number
14. EIA-485 Communication Bus Trouble
15. System Off-Normal Code
16. System Automatic Test Report
17. System Abnormal Automatic Test Report
18. Manual Activated Test Report
Event Restorals
19. General Alarm Restoral
20. Zone/Point Alarm #N Restoral
21. General Supervisory Restoral
22. Zone/Point Supervisory #N Restoral
23. General System Trouble Restoral
24. AC Power Loss Restoral
25. Zone/Point Trouble #N Restoral
26. Low Battery Restoral
27. Telco Primary Line Fault Restoral
28. Telco Secondary Line Fault Restoral
29. NAC Fault Code Restoral
30. Communication Trouble, Primary Number Restoral
31. Communication Trouble, Secondary Number Restoral
32. EIA-485 Communication Bus Trouble Restoral
33. System Off-Normal Code Restoral
Where #N represents the number of zones or devices in alarm or trouble. This is valid
for all formats except Ademco Contact ID.
For all formats, the 'general' reports are always transmitted (unless disabled). The
zone or point information may follow the general report if enabled.