Section 4, Network Turnup Procedure | TRACER 5045 System Manual |
|
|
1.INTRODUCTION
This section discusses the installation process of the TRACER 5045 system.
Changes or modifications not expressly approved by ADTRAN could void the user’s authority to operate the equipment.
2.TOOLS REQUIRED
The tools required for the installation of the TRACER 5045 are:
•VT100 terminal or PC with terminal emulation software
•
To prevent electrical shock, do not install equipment in a wet location or during a lightning storm.
3.UNPACK AND INSPECT THE SYSTEM
Each TRACER 5045 is shipped in its own cardboard shipping carton. Open each carton carefully and avoid deep penetration into the carton with sharp objects.
After unpacking the unit, inspect it for possible shipping damage. If the equipment has been damaged in transit, immediately file a claim with the carrier, then contact ADTRAN Customer Service (see Customer Service, Product Support Information, and Training information in the front of this manual).
Contents of ADTRAN Shipment
Your ADTRAN shipment includes the following items:
•TRACER 5045 Unit
•TRACER 5045 Quick Start Guide
•TRACER 5045 Documentation CD
Customer Provides
The following items are necessary for the installation of the TRACER 5045 system and are not provided by ADTRAN:
•21 to 60 VDC power source (or AC adapter available from ADTRAN P/N 1280650L1), either polarity referenced to ground
•Antenna and mounting hardware
•Antenna feedline cable
•Ethernet cables
36 | © 2003 ADTRAN, Inc. |
