ADTRAN T1-FT1 user manual # of Chan, Normal Mode of Operation

Chapter 3. Operation

# OF CHAN

Used to select the number of DS0s (channels) that are to be used. The corresponding DTE rate will be this number times 56K or 64K, depending on Port Option number 1.

Choices: 01 through 24

DATA

Used to control the inverting of the DTE data. This inversion can be useful when operating with an HDLC protocol. Often used as a means to ensure ones (1s) density. TSUs on both ends must have identical option settings.

Choices: NORMAL or INVERT

CTS

Used to control characteristics of CTS.

Choices: NORMAL, (see Table 3-1) or FORCE ON

DCD - Data Carrier Detect -

Indicates to the DTE when a valid signal is being received at the Network Interface.

Choices: NORMAL, (see Table 3-1) or FORCE ON

DSR - Data Set Ready

This signal indicates to the DTE when the DCE is turned ON and ready for operations.

Choices: NORMAL, (see Table 3-1) or FORCE ON

Table 3-1. Normal Mode of Operation

NORMAL MODE OF OPERATION

Conditions which cause the Port Control Signals to be deactivated.

SIGNAL	RTS	V-54	511 TEST	SELFT TEST	NETWK TEST	NETWORK
		LOOPBK	ON	ACTIVE	ACTIVE	ALARMS
CTS	Follows	OFF	OFF	OFF	OFF	YELLOW
						ALM
DCD	-	-	OFF	-	PATTERN	OOF
						OR
						AIS
DSR	-	OFF	OFF	OFF	OFF	-
Where “=” = don’t care
Force On = On under all conditions

3-20 TSU User Manual 61200060L1-1