AEG MCD2660E, MCD2661E operating instructions Installation, Installing The Appliance

UK

Installation

INSTALLING THE APPLIANCE

1.Remove all packaging and check carefully for any signs of damage.

2.If fitting the microwave oven above a conventional oven (position A) then use the mylar sheet provided.

a.Cut the Mylar sheet to fit the internal width of the unit.

b.Peel back the protective cover on the tape and fix to the rear of the shelf

so that it covers the service gap. (See diagram).

Mylar sheet

Internal	width
Conventional	gap
	Service
oven

3.Fit the appliance into the kitchen cupboard slowly, and without force, until the front frame of the oven seals against the front opening of the cupboard.

4.Ensure the appliance is stable and not leaning.

Ensure that a 5mm gap is	5 mm
kept between the cupboard
door above and the top of
the frame (see diagram).
5. Fix the oven in position with the
screws provided.
The fixing points are located on
the top and bottom corners of
the oven (see diagram, item 10,
on page 5).

6.It is important to ensure that the installation of this product conforms to the instructions in this operation manual and the conventional oven manufacturer’s installation instructions.

The microwave can be fitted in position A or B:

Chimney	Chimney
Position A	Position B

Conventional

oven

POSITION		NICHE SIZE		CHIMNEY	Gap Between
	W	D	H	(min)	Cupboard & Ceiling
A	560 x 550 x 450			50	50
	560 x 550 x 380			50	50
B	560 x 500 x 450			40	50
	560 x 500 x 380			40	50

Measurements in (mm)

NOTE: Ensure the bottom of the oven is 85 cm or more above the floor.

49