Making a Basic Measurement
Viewing a Signal
Viewing a Signal
| 1. | Press Preset. If the softkeys Factory Preset and User Preset appear, |
|
| select Factory Preset. |
| 2. | Press System, Reference, then note the 10 MHz Out setting. If Off is |
|
| active (underlined), press the softkey to toggle the reference on. |
| 3. | Connect the analyzer’s rear panel 10 MHz OUT (SWITCHED) to the |
|
| |
| Setting Reference Level and Center Frequency | |
| The display examples in this section are made using various analyzer | |
NOTE | ||
| models, you may see some variations depending upon your analyzer. | |
| 4. | Set the reference level to 10 dBm: Press AMPLITUDE, 10, dBm. |
| 5. | Set the center frequency to 30 MHz: Press FREQUENCY, Center |
|
| Freq, 30, MHz. |
|
| The 10 MHz reference signal spectrum appears on the display, as |
|
| shown in Figure |
| The display examples in this book are made using various analyzer | |
NOTE |
models, you may see some variations depending upon your analyzer.
Making a Basic Measurement
40 | Chapter 3 |