Agilent Technologies SMPTE 310M Configuring the software

Configuring the software

Configuring the software

Because the SMPTE 310M interface receives and transmits data via the

MPEGscope SPI interface, you do not need special SMPTE 310 interface software.

You can set receiver and transmitter options from the SPI interface application, as

illustrated below.

1Select the SPI interface.

For information about this dialog, press

the Help button.

Contents

Main Page i Certification ISM 1A Additional Information for Test and Measurement Equipment Warnings Safety Symbols ii WARNING CAUTION Certification Informations complmentaires relatives l quipement de test et de mesure ISM 1A iii Page Right Introduction MPEGscope Plus and MPEGscope Lite MPEGscope Portable and Portable Lite Page Introduction Location Number MPEGscope Plus and MPEGscope Lite Step 1: Remove the cover Page Step 2: Remove optional interface Page Step 3: Install SMPTE interface Page Step 4: Replace the cover Page MPEGscope Portable and Portable Lite Step 1: Remove the cover Page Step 2: Remove optional interface Page Page Step 4: Replace the cover Page Connecting to the SMPTE 310M interface Configuring the software Page Page SMPTE 310M interface specifications Release Notes Release Notes Initial startup with sparse streams Large bit rate changes