9
MPEGscope Plus and MPEGscope Lite
Alternative
configuration
This configuration applies only if your MPEGscope is housed in a Kayak XU PC
(e.g., E6277B or E6277C). It enables you to have both the SMPTE 310M interface
and another optional line interface (e.g., the ASI & Serial ECL (DHEI) interface)
installed at the same time. The configuration requires repositioning all
MPEGscope cards into the first four slots, and replaces Steps 2 and 3 on pages 6
to 8. Follow all other steps as usual.
2Remove the blank faceplate
and install the Real-time
Analyzer card into slot 1.
4Install the optional line
interface (e.g., the ASI &
Serial ECL (DHEI) interface)
into slot 2.
3Attach the IAB ribbon cable to
the MPEGscope main card then
install the card into slot 3.
7Connect the ribbon cable from
the MPEGscope main card to the
Real-time Analyzer card.
5Connect the IAB ribbon cable from
the MPEGscope main card to the
optional line interface (e.g., the ASI
& Serial ECL (DHEI) interface).
6Install the SMPTE 310M
interface card into slot 4.
1Remove the cards from slots 2, 3 and 4, disconnecting cables as necessary.