5.Secure the relay pack near the battery of the ATV or other location on the ATV out of harms way.

6.Thread the 3 wire lead from the relay pack forward through the ATV frame on the same side as the handle bar switch. Avoid threading wire close to moving parts, hot parts or pinch points. Use 1 or 2 nylon ties to hold wire in place.

7.Connect the three leads from the handlebar switch into the three leads from the relay pack matching up the red, green and black wires. See Figure 4.

8.Thread the bullet connector from the relay pack forward through the frame and out through the front of the ATV. Avoid threading wire close to moving parts, hot parts or pinch points. Use 1 or 2 nylon ties to hold wire in place.

9.Plug the bullet connector from the relay pack into the bullet connector on the actuator.

10.Attach the red wire from the fuse to the positive terminal on the ATV battery. Attach the negative lead (black wire) from the relay pack to the negative terminal on the ATV battery.

11.Use the handlebar switch to fully extend the actuator, then disconnect the actuator.

ACTUATOR

HANDLEBAR

SWITCH

POSITIVE "HOT" POST

BATTERY

+

BULLET

CONNECTOR

3-WIRE

LEAD BLACK

RED

FUSE

RELAY PACK

figure 4

12.Attach the tethered safety switch to the handlebar using

(4) pre-assembled screws and (4) pre-assembled nuts.

See figure 5.

13.Thread the wiring through the ATV and out the front of the ATV. Avoid threading wire close to moving parts, hot parts or pinch points. Nylon ties can be used to hold wire in place.

PRE-ASSEMBLED SCREW

PRE-ASSEMBLED

NUT

figure 5

6