16.Attach the bent rear frame tube to the push channel using (2) 1/2" x 3-1/2" hex bolts, (4) 1/2" washers and

(2) 1/2" nylock nuts. Do not tighten yet.

17.Remove the concrete block from under the engine and place it underneath the the end of the rear frame

tube.

1/2" WASHER

1/2" NYLOCK NUT

1/2" x 3-1/2"

HEX BOLT

REAR FRAME TUBE

figure 15

18.Attach the support bracket to the mounting tubes using

(4) 5/16" x 1-3/4" hex bolts, (8) 5/16" washers and (4) 5/16" nylock nuts. Tighten.

5/16" NYLOCK NUT

5/16" WASHER

5/16" WASHER

5/16" x 1-3/4"

HEX BOLT

figure 16

19.Place the wheel assembly behind the engine mounting base.

20.Fasten the bottom of the anchor brackets (part of wheel assembly) to the outside of the mounting tubes using (4) 1/2" x 2-1/4" hex bolts, (4) 1/2" washers (on inside of mounting tube) and (4) 1/2" nylock nuts. Do not tighten yet.

21.Fasten the tops of the anchor brackets to the engine mounting base using (4) 5/16" x 1" hex bolts and (4) 5/16" nylock nuts. Do not tighten yet.

22.Tighten all nuts and bolts assembled in steps 12- 14 and 18-21. Do not tighten the nuts and bolts assembled in steps 15-16at this time.

NOTE: Complete wheel assembly not shown for clarity.

5/16" x 1"

HEX BOLT

ANCHOR BRACKET

5/16" NYLOCK

NUT

1/2" NYLOCK

NUT

1/2" WASHER

1/2" x 2-1/4"

HEX BOLT

figure 17

NOTE: Before proceeding with next assembly step, make sure the actuator is fully extended. Refer to step 11 on page 6 in the Wiring Assembly Section.

23.Fasten top of actuator to wheel assembly using (1) 1/2" x 3" clevis pin, (2) .5" x 1" x .59" spacers and (1) hairpin.

24.Fasten bottom of actuator to actuator bracket using (1) 1/2" x 2" clevis pin and (1) hair pin.

1/2" x 3"

.5" x 1" x .59"

1/2" x 2"

SPACERS (2)

CLEVIS PIN

CLEVIS PIN

 

 

HAIRPINS (2)

figure 18

9