Agri-Fab 45-0418 NOTE:, figure, figure, figure, figure, figure, CAUTION, outside, Do not tighten yet, Do not tighten yet, Do not tighten yet

11.Place a 15" concrete block underneath the snow thrower, beneath the engine. See figure 10.

CAUTION: Use caution while working on snow thrower when it is propped up on concrete block.

13.Attach the front holes of the housing anchor straps to the weld bolts on the housing using (2) 1/2" lock nuts. Do not tighten yet.

figure 10

12.Attach the housing anchor straps to the outside of the mounting tubes using (4) 1/2" x 2-1/4" hex bolts, (8) 1/2" washers and (4) 1/2" nylock nuts. Do not tighten yet.

	ANGLE
	SLOPES
	BACKWARD
HOUSING
ANCHOR
STRAP	1/2" NYLOCK
MOUNTING	NUT
TUBE
	1/2" WASHER
	1/2" X 2-1/4"
	HEX BOLT

figure 11

1/2" LOCK NUT

figure 12

14.Secure the mounting tubes to the side support straps using (2) 1/2" x 2-1/4" hex bolts, (4) 1/2" washers (inside and outside) and (2) 1/2" nylock nuts. Do not tighten yet.

NOTE: Concrete block not shown for clarity.

1/2" X 2-1/4"

HEX BOLT

1/2" WASHER

1/2" NYLOCK NUT

figure 13

15.Place the push channel over the ends of the mounting tubes. Line up the holes as shown in the figure below and secure the push channel using (2) 1/2" x 3-1/2" hex bolts, (4) 1/2" washers (one on each side) and (2) 1/2" nylock nuts. Do not tighten yet.

PUSH

CHANNEL

1/2" NYLOCK
NUT	1/2" x 3-1/2"
1/2" WASHER	HEX BOLT

figure 14

8