SECTION 6: HEATER INSTALLATION
WARNING
Severe Injury Hazard
Secure burner to burner tube with bolts and lockwashers.
Hang heater with materials with a minimum working load of 75 lbs (33 kg).
Failure to follow these instructions can result in death, injury or property damage.
Expansion and contraction of the tube dictates that the minimum suspension lengths in the table on Page 13, Figure 14 be maintained.
WARNING
Cut/Pinch Hazard
Wear protective gear during installation, operation and service.
Edges are sharp.
Failure to follow these instructions can result in injury.
To ensure your safety, and comply with the terms of the warranty, all units must be installed in accordance with these instructions.
The gas or the electrical supply lines must not be used to support the heater.
Do not locate the gas or electric supply lines directly over the path of the flue products from the heater.
The heater must be installed in a location that it is readily accessible for servicing.
The heater must be installed in accordance with clearances to combustibles as indicated on the heater and in this instruction manual.
The gas inlet pressure must be maintained as indicated on the rating plate.
Typical installation configurations are shown on Page 13, Figure 14.
12 of 71
