SECTION 5: MAJOR COMPONENTS
FIGURE 13: Major Component Descriptions
Burner with Tube Gasket | Reflector |
Must be installed with the | (Aluminum or |
flame observation | Stainless |
window facing down. | Steel) |
| Alternate overlap as |
| shown on overview and |
| on Page 15, Figure 16. |
| Minimum overlap is 6" (16 cm). |
Burner Tube | Tube | |
Supplied in 10' | ||
Heat treated | ||
(3 m) lengths. Burner | ||
aluminized tube supplied | ||
tube is always the first tube | ||
in 10' (3 m) lengths. | ||
after the burner. | ||
| ||
Tube and Reflector Hanger | Coupling Assembly | |
with Lock | ||
with Clamp Package | ||
| ||
Position this hanger no more |
| |
than 4" (10 cm) away from the |
| |
burner. | Reflector End Cap | |
| ||
| Punch out center | |
Tube and Reflector Hanger | section to | |
accommodate tube. |
Suspend system from these hangers.
Vent Adapter
Reflector Support Strap &
Wire Form
| Turbulator |
| Turbulator must |
| be installed in the last |
| standard section of tube. |
Flex Gas Line with | Turbulator is not required on the |
Shut Off Cock | |
| Page 18, Section 6.4. |
10 of 71
