Aiphone IS Series operation manual Other buttons, Sub stations, How to select multiple stations

Registering stations and PA outputs [System setting – Registering stations]

Register all the stations and PA outputs connected in the system, and set the area, station no., station name (or PA output name) and type of station (for sub stations: video door/ audio door/room sub stations) to them.

1 Click Registering stations in the table of contents.

2 Set the area, station no., station name and type of station (for sub stations) to the target stations, and enter names to the target PA outputs.

*Setting the station no. is required.

*Shows a port no. of the control unit to connect with a station.

*It is required to enter a name to the target PA output when an external unit is connected to the corresponding PA output terminals.

*For a cell with the mark, select the target one from the pull-down menu.

*Do not set stations with the same number in an area.

NOTE:

The name of a master station displayed on its monitor in standby mode is up to 16 alphanumeric characters.

Other buttons

•Connection check

Click to confirm the connected units.

Connected: yellowish green

Not connected: gray

Station type error: pink

•[Collective setting]:

The following buttons are used to make the settings to all the checked stations at one time.

*Pressing each button opens another window.

NOTE:

Be sure to check all the target stations before using these buttons.

•Area

Click to set the same area number to all the checked stations.

•Station number

	Click to assign sequential numbers to all the checked
	stations from top to bottom. The number you enter will
	be set as the first number and will be assigned to the top		GETTING
	station of the ones checked. Other checked stations will
	be numbered sequentially.		STARTED
•
	Station name
	Click to assign the same station (and/or PA output) name
	and sequential numbers to all the checked stations (and/
	or PA outputs) from the top down. Enter a name only.
•		(sub stations)
	Station type		SETTING
	stations.
	Click to set the same station type to all the checked sub
How to select multiple stations			THE
	register.		SYSTEM
○ Click to check the stations and PA outputs you will
			USING THE SYSTEM
○ By clicking the button for the control unit, all the stations
	and PA outputs connected to it are checked or canceled.
			APPENDIX

○By clicking the button on the top of the list, you can check or cancel all the stations and PA outputs on the list.

3 Click Temporarily stored to save the current setting results temporarily.

*If you wish to cancel the setting results you have made, click a title in the table of contents or “Refresh” in the web browser menu.

13