Aiwa LCX-350 manual Setting the Timer, Timer Recording, Prepare the source

SETTING THE TIMER

11

1,2,3,42,4

3

6

u

The unit can be turned on at a specified time with the built-in timer,

Preparation

Make sure the clock is set correctly, (See page 5.)

Use the remote control.

1 Press the TIMER button repeatedly while pressing the SHIFT button to display 0, and press the 11 button within 6 seconds.

O is displayed, and the hour flashes.

if you do not press the II button within 6 seconds, another operation may start.

2 Designate the hour of the timer-on time by

pressing the - or* button, and the 11 button. Repeat to designate the minute of the timer-on time.

After you designate the timer-on time, one of the source name

flashes alternately on the display.

3 Press the FUNCTION button repeatedly to select a source and press the II button.

You can select a source by pressing the < or FP button as well.

o If the tuner is selected, the band cannot be selected in this step.

4Select the duration for the timer-activated period with the ++ or ➤> button and press the 11 button.

The duration for the timer-activated period can be set between 5 and 240 minutes in 5-minute steps.

5 Prepare the source.

To listen to a CD, load the disc.

To listen to a tape, insert the tape into the deck.

To listen to the radio, select the desired band and tune into

a station.

To listen to the equipment connected to the AU}( jaclks,

set the timer of the connected source (with an external timer)

and prepare for the play.

6Press the POWER button to turn the unit otf afiter adjusting the volume and tone.

@ remains on the display after the power is turned off (timer standby mode).

When the timer-on time is reached, the unit turns on and begins play with the selected source.

To check the specified time and source

Press the TIMER button while pressing the SHIFT button on the remote control. The timer-on time, the selected source name and the duration for the timer-activated period are displayed for 4 seconds.

TIMER RECORDING

Timer recording is applicable for TUNER and AUX (with an external timer) sources only.

Press the TIMER button repeatedly while pressing the SHIFT button on the remote control so that @ and

~appear on the display, and press the II button.

Repeat the steps shown above from step 2 and insert 1he tape to be recorded into the deck after step 5.

To cancel timer stanby mode temporarily

Press the TIMER button while pressing the SHIFT button on the

remote control so that @ (and ~) disappear on the display. To restore the timer standby mode, press again to display 0 (and m).

Using the unit while the timer is set

You can use the unit normally after setting the timer.

Before turning off the power, repeat step 5 to prepare the source, and adjust the volume and tone.

m

-Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

15 ENGLISH