Aiwa LCX-350 GIs, s [s, Pages, GENERAL, ‘To reset, TUNER SECTION, CD PLAYER SECTION, ‘There is no sound, CASSETTE DECK SECTION, The tape does not run

TROUBLESHOOTING GUIDE

if the unit fails to perform as described in these Operating Instructions, check the following guide.

GENERAL‘There is no sound.

s [s the AC cord connected properly?

o Is there a bad connection? (- page 3)

. Was an incorrect function button pressed?

The sound becomes inaudible or the unit is turned off suddenly.

●There may be a short circuit in the speaker terminals.

-+ Disconnect the AC cord from the AC outlet and re-connect the speaker cords correctly. Then connect the AC cord and turn the unit on again,

Sound is emitted from one speaker only.

●Is the other speaker disconnected?

An erroneous display or a malfunction occurs,

+Reset the unit as stated below.

TUNER SECTIONThere is constant, wave-like static.

●Is the antenna connected properly? (+ page 3) “Is the signal weak?

-+ Connect an outdoor antenna.

The reception contains noise interferences or the sound is distorted.

●Is the system picking up external noise or multipath distortion?

.+ Change the orientation of the antenna.

.+ Move the unit away from other electrical appliances.

CASSETTE DECK SECTIONThe tape does not run.

●Is the deck in pause mode? (+ page 11)

The sound is off-balance or not adequately high.

GIs the playback head dirty? (+ page 18)

Recording is not possible.

“Is the erasure prevention tab on the tape broken off? (+ page 11)

. 1s the recording head dirty? (+ page 18)

Erasure is not possible,

. Is the erasure head dirty? (- page 18)

. Is CrOz or metal tape being used?

High frequency sound is not emitted,

●Is the recording/playback head dirty? (-J page 18)

CD PLAYER SECTIONThe CD player does not play.

●Is the disc correctly inserted? (+ page 9)

. IS the disc dirty? (+ page 18)

●Is the lens affected by condensation?

+ Wait approximately one hour and try again.

‘To reset

If an unusual condition occurs in the display window or the cassette decks, reset the unit as follows.

1Press the POWER button to turn off the power.

2Press the VOLUME A button to turn the power back on while

pressing the 9 button. Everything stored in memory after purchase is canceled.

If the power cannc)t be turned off in step 1 because of a malfunction, reset by disconnecting the AC cord and repeat step 2.

PARTS INDEX

Instructions about each part on the main unit or remote control are indicated on the pages listed below.

ENGLISH20