MANUAL TUNING

BANDI

MODE

TUNER

SHIFT

1 Press the TUNER button repeatedly to select the desired band.

m

If the power is turned off, the previously tuned station will be played (Direct Play Function).

\AJhen using the remote control, press the BAND/MODE “WNER button repeatedly while power is on.

2Press the q< or > button to select a station.

Each time the button is pressed the frequency changes. \Nhen a station is received, “TUNE’r is displayed for 2 seconds.

During FM stereo reception, “STEREO” is displayed.

To search for a station quickly (Auto Search)

Keep the +< or F button pressed until the tuner starts searching for a station, After tuning in to a station, the search Stolps,

To stop the Auto Search manually, press the <<or ›~ button.

*The Auto Search may not stop at stations with very weak signals.

When an FM stereo broadcast contains Inoise

Press the BAND/MODE TUNER button while pressing the SHIFT button on the remote control.

“MONO” appears on the display.

Noise is reduced, although reception is monaural.

m

To restore stereo reception, press the buttons again.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Press the POWER button while pressing the TUNER button during power on.

TO reset the interval, repeat this procedure,

Bm

When the AM tuning interval is changed, all preset stations

(see “PRESETTING STATIONS”) are cleared. The preset !stations have to be set again.

7 ENGLISh!