Aiwa NSX-A909 manual Press CLOCWTIMER m, then press II SET within 4 seconds, Press SLEEP, English

2,3

.. —.+

k4

1 Press CLOCWTIMER m, then press II SET within 4 seconds.

2 Press - DOWN or - UP to designate the hour, then press II SET.

The hour stops flashing and the minute starts flashing.

3 Press + DOWN or - UP to designate the minute, then press 11 SET.

The minute stops flashing on the display and the clock starts from 00 seconds.

To disdav the current time

Press CLOCK. The time is displayed for 4 seconds. However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press the CLOCK and then press ■ within 4 seconds. Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

‘MULTI JOG is also available instead of 44 and*.

‘ENTER is also available instead of II SET.

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP.

2 Within 4 seconds, press + or FF to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off

Press SLEEP once. The remaining time is displayed for 4

seconds.

To cancel the sleep timer

Press SLEEP twice so that ‘(SLEEP OFF appears on the display.

* MULTI JOG is also available instead of 44 and W.

23 ENGLISH