Aiwa NSX-V9000 manual Basic Recording, Inserting Blank Spaces, Preparation, To erase a recording

BASIC RECORDING

This section explains how to record from the tuner, CD player, or external equipment.

.’, ._ ,,. ,_

4

‘1

Preparation

●Set the tape to the point where recording will start.

●Use Type I (normal) and Type II (high/CrOz) tapes for recording.

1Insert the tape to be recorded on into deck 2. Insertthe tape with the side to be recordedon first facing out from the unit and the exposed side down.

A

I4

2Press the REV MODE button to select the reverse mode.

To record on one side only, turn on =.

To record on both sides, turn on 1) or C=).

3Press the DOLBY NR button to turn Dolby NR on or off.

To record with DOLBY NR, turn on m NR. To record without DOLBY NR, turn off UI NR.

4Press one of the function buttons and prepare the source to be recorded.

To record from a CD, press the CD button and load the disc(s).

To record from a radio broadcast, press the TUNER button and tune in to a station.

To record from the connected source, press the VIDEO/ AUX button and play.

5Press the ● REC/REC MUTE button to start recording.

When the selected function is CD, playback and recording start simultaneously.

To stop recording, press the ■ button.

To pause recording, press the 11 button. (Applicable when the source is TUNER, VIDEO/AUX.) To resume recording, press again.

To start recording with the remote control

First press the ●/0 REC/REC MUTE button, and then press the + F button within 2 seconds.

INSERTING BLANK SPACES

Insertion of 4-second blank spaces enables activation of the Music Sensor function. (Applicable when the source is TUNER or VIDEO/AUX.)

1 Press the. REC/REC MUTE button during recording or while in recording pause mode.

~on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode,

2Press the II button to resume recording.

To insert a blank space of less than 4 seconds, press the ●

REC/REC MUTE button again while ~ is flashing.

To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the ● REC/REC MUTE button again. Each time the button is pressed, a 4-second blank space is added.

To erase a recording

Make sure the microphone is not connected to this unit.

1Insert the tape to be erased into deck 2 and press the TAPEI DECK 112button to display “TAPE2.

2Set the tape to the point where the erasure is to be started.

3Set the reverse mode by pressing the REV MODE button.

4Press the ● REC/REC MUTE button to start the erasure.

13 ENGLISH