Aiwa NSX-V9000 manual To stop recording, To clear the edit program

Al EDIT RECORDING

The Al edit function enables CD recording without worrying about tape length and track length. When a CD is inserted, the unit automatically calculates track lengths. If necessary, the order of tracks is rearranged so that no track is cut short.

(Al: Artificial Intelligence)

Al edit recording will not start from a point halfway into the tape. The tape must be recorded from the beginning of either side.

Use the remote control from steps 3 to 6.

1 Insert the tape into deck 2, and press the DOLBY

NR button to turn Dolby NR on or off.

Insert the tape with the side to be recorded on first facing out from the unit.

2Press the CD button and load the disc(s).

3Press the EDIT/CHECK button once.

,,-- .-,, ,. , . , ...,.,.,, .,, .,

“tul i ~~Ilgnm up ana ““~rrlasnes on me alsplay.

mm

Each time it is pressed, the display changes as follows. Al EDIT — PRGM EDIT

4 Press one of the DISC DIRECT PLAY buttons to select a disc.

5 Press the numeric buttons to designate the tape length.

10 to 99 minutes can be specified.

Example: When using a 60-minute tape, press the 6 and O buttons.

In a few seconds, the microcomputer determines the tracks to be recorded on each side of the tape.

●The •~ and FE buttons are also available to desicmate

the tape length.	Remaining	Selected
Tape length
	time of side A	tracks for side A
I

Tape side A (front side)

6 First press the ./0 REC/REC MUTE button and

then press the <b button within 2 seconds to start recording.

The tape is rewound to the beginning of the front side, the lead segment is played through for 10 seconds, and recording starts. When recording on the front (side A) ends, recording on the back (side B) starts.

To stop recording

Press the ■ button. Recording and CD play stop simultaneously.

To clear the edit program

Press the ■ CLEAR button twice so that “EDIT”disappears on the display.

To check the order of the programmed track numbers

Before recording, press the EDIT/CHECK to select side A or B, and press the ++ or b~ button repeatedly.

Program Programmed

number track numbers

Tape side Track number

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can add tracks from other discs in the CD compartment.

1Press the EDIT/CHECK button to select side A or B.

2Press one of the DISC DIRECT PLAY buttons to select a disc.

3Press the numeric buttons to select tracks.

❑goes out and -{ starts flashing on the display.

A track which has a playing time longer than the remaining time cannot be programmed.

4 Repeat steps 2 and 3 to add more tracks.

Time on cassette tapes and editing time

The actual cassette recording time is usually a little longer than the specified recording time printed on the label. This unit can program tracks to use the extra time. When the total recording time is a little longer than the tape’s specified recording time after editing, the display shows the extra time (without a minus mark), instead of the time remaining on the tape (with the minus mark).

m

●Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.

●The Al edit function cannot be used with discs containing 31 tracks or more.

15 ENGLISH