Aiwa NSX-V9000 Dspsurround, Manual Tuning, Press the l DOWN or H UP button to select t a station

DSPSURROUND

SURROUND

.— __ _—.

The DSP (Digital Signal Processor) surround circuits can recreate the effect of sounds reflected from walls or ceilings, to obtain the sound presence of real environments.

There are three modes with matching graphic equalization curves.

Press the SURROUND button repeatedly until the desired

SURROUND mode is displayed.

~DISCO+LIVE+HALL+ S-oFF]

I(cancel)

Equalization curves are selected automatically to match the SURROUND modes and can also be selected or turned off to suit your preference.

When the music source is monaural

Select LIVE to obtain a simulated stereo effect. When DISCO or HALL is selected, no sound will be heard from the surround speakers.

To cancel the selected mode

Press the selected button again. S-OFF is displayed.

While SURROUND mode is off, no sound is heard from the surround speakers.

m

When a connected microphone is used, the SURROUND mode is automatically canceled.

MANUAL TUNING

REPEATI

MONO

TUNER

_—.

1 Press the TU kER/BAND button repeatedly to select the des red band.

FM — AM

If the power is tur ed off, the previously tuned station will be played (Direct Pla Function).

2 Press the l<< DOWN or ➤H UP button to select t-----

a station.

Each time the but on is pressed, the frequency changes. When a station is r ceived, “TUNE is displayed for 2 seconds,

During FM stereo reception, 1[10111is displayed.

1

To search for a st ion quickly (Auto Search)

KeepIthe 1<< DOW or FFI UP button pressed until the tuner starts searching for station. After tuning in to a station, the search stops.

To stop the Auto Sea ch manually, press the 1<< DOWN or ➤>1 UP button.

● The Auto Search ay not stop at stations with very weak signals.

When an FM stere broadcast contains noise

Press the REPEAT/ ONO TUNER button on the remote control so that “MONO app ars on the display.

Noise is reduced, alt ough reception is monaural.

To restore stereo re eption, press the button so that MONO disappears. 1

To change the AM uning interval

The default setting o the AM tuning interval is 10 kHz/step. If you use this unit in an rea where the-frequency allocation system is 9 kHz/step, chang Ithe tuning interval.

Press the POWER utton while pressing the TUNER/BAND button.

To reset the interval, epeat this procedure.

When the AM tuning i terval is changed, all preset stations (see “PRESETTING STA IONS) are cleared. The preset stations have to be set againi.

7 ENGLISH