Aiwa NSX-V9000 Programmed Edit Recording, 4,55, Repeat for the rest of the tracks for side A

PROGRAMMED EDIT RECORDING

3,7

5

4,55

82

■

Programmed edit function enables CD recording while checking the remaining time on each side of the tape as the tracks are programmed.

The programmed edit recording will not start from a point halfway in the tape. The tape must be recorded from the beginning of either side.

Use the remote control from steus 3 to 8.

1 Insert the tape into deck 2, and press the DOLBY NR button to turn Dolby NR on or off.

Insert the tape with the side to be recorded on first facing out from the unit.

2 Press the CD button and load the disc(s). 3 Press the EDIT/CHECK button twice.

“EDIT”lights up and “PRGM”flashes on the display,

mm

4 Press the numeric buttons to designate the tape length.

10 to 99 minutes can be specified.

Example: When using a 60-minute tape, press the 6 and O buttons.

	Maximum recording
Tape length	time for side A

Tape side A (front side)

5 Press one of the DISC DIRECT PLAY buttons to select a disc and press the numeric buttons to program a track.

Example: To ~iect the 10th track of disc 2, press DISC DIRECT PLAY 2 and the numeric buttons +1O and O.

6Repeat step 5 for the rest of the tracks for side A.

A track whose playing time is longer than the remaining time cannot be programmed.

Remaining time of side A

Total number Programmed of programmed tracks tracks

7 Press the EDIT/CHECI< button to select side B and program the tracks for side B.

After confirming B on the display, repeat step 5.

Tape side B (reverse side)

1

8 Press the W(3 REC/RIEC MUTE button and then

press the <b button within 2 seconds to start recording.

The tape is rewound to Ithe beginning of the front side, the lead segment is played through for 10 seconds, and recording starts. When recording cm tile front side (A) ends, recording on the back side (B) starts.

To stop recording

Press the H button. Recording and CD play stop simultaneously.

To check the order of the programmed track numbers,

Before recording, press the EDIT/CHECK button to select side A or B, and press the +< or Ihb button repeatedly.

Program number

Track number Programmed track numbers

To change the program of e:ach side

Press the EDIT/CHECK button to select side A or B, and press the ■ CLEAR! button to clear the program of the selected sicje. Then program tracks again.

To clear the edit program

Press the ■ button twice so tlhat“EDIT”disappears on the display.

m

Recording is inhibited if the erasure prevention tab on either side of the tape is broken off.

ENGLISH 16