Aiwa XR-MS3 manual Basic Recording, Inserting Blank Spaces, To Erase Recording

TAPE RECORDING

BASIC RECORDING

2

	wREC/REC MUTE
FUNCTION	DOLBY NR 6 1
4
7
JOG MODE
5	SHIFT
VOLUME/
MULTI JOG

Preparation

•Set the tape to the point where recording will start.

•Use Type I (normal) and Type II (high/CrO2) tapes for recording.

1 Press TAPE on the remote control, or press FUNCTION on the main unit repeatedly until "TAPE" appears on the display.

2Press zTAPE EJECT to open the cassette holder.

3Load the tape to be recorded with the side to be recorded on first facing upward.

Insert the tape fully into the cassette holder until it clicks, then push the cassette holder to close.

4Press REV MODE to select the reverse mode.

To record on one side only, select p.

To record on both sides, select [ or ].

When recording from the side facing downward, the tape stops at the end of recording of this side, even if the reverse mode is set to [or ].

5Turn Dolby NR on or off using DOLBY NR on the main unit, SHIFT and DOLBY NR on the remote control, or JOG MODE and VOLUME/MULTI JOG on the main unit. (See page 11, "PLAYING BACK

A TAPE" for details.)

To record with DOLBY NR, turn on the h NR indication.

To record without DOLBY NR, turn off the hNR indication.

6Select and prepare the source to be recorded.

To record from a radio broadcast, press TUNER/BAND and

tune in to a station.

To record from a CD, press CD on the remote control, then load the disc and press f or gto select the track to be recorded first.

To record from the equipment connected to the VIDEO/

AUX jacks, press AUX on the remote control, and prepare to play.

• You can use FUNCTION on the main unit to select the source.
If the source to be recorded is a radio broadcast, first press
FUNCTION so that "FM" or "AM" appears, then press	PLAYING
TUNER/BAND to select the band.
7 Press wREC/REC MUTE to start recording.
When recording from a CD, CD play and tape recording start
simultaneously.	CD
When recording from connected equipment, start play of the
connected equipment.	TAPE RECORDING
To stop recording, press s.
When recording from a CD, press s again to stop play.
To pause recording, press a. (Applicable when recording from
a radio broadcast or connected equipment.) To resume recording,
press again.

INSERTING BLANK SPACES

4-second blank spaces can be inserted at the desired point during recording. (Applicable when the source is a radio broadcast or connected equipment.)

1Press w REC/REC MUTE during recording or while in recording pause mode.

4 flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck enters the recording pause mode.

2Press a to resume recording.

To insert a blank space of less than 4 seconds, press w REC/REC MUTE again while 4 is flashing.

To insert a blank space of more than 4 seconds, after the

deck enters recording pause mode, press w REC/REC MUTE again. Each time the button is pressed, a 4-second blank space En is added.

TO ERASE RECORDING

1Load the tape to be erased into the deck.

2Set the tape to the point where the erasure is to be started.

3Press AUX on the remote control.

If optional equipment is connected to the VIDEO/AUX jacks, turn it off.

4Press wREC/REC MUTE to start erasure.

ENGLISH 15