
INTRODUCTION
Your Mower is designed primarily for weed and grass control, shredding row crops such as cotton and corn stalks, and cutting small brush up to 2" in diameter. With proper maintenance as described in this manual, your Mower will provide you with years of dependable service with a minimum of repairs.
It is recommended that all operators of this implement read this manual or be instructed of its contents as to safety, proper operation, and maintenance before beginning operation.
Your Mower has been assembled to operate with a tractor PTO input speed of either 540 or 1000 RPM,but not both. This machine is designed for use with tractors rated 50 HP (37kW) to 130 HP (98kW).
When ordering parts for the Gearboxes and the Drivelines, be sure to specify the serial number. The serial number is located outside of the right Tongue attaching Plate on the center Mainframe section.
Chain Guards are extra equipment. Deflectors, Driveline Integral Shields and Gearbox Shields are standard equipment and are to be used at all times.
To place the warranty into effect, fill out the warranty card in full, giving all the requested information, and mail promptly. Be sure to give the serial number of this Mower.
For
At least 20% of the tractor’s total weight must be on the front tires with the Cutter lifted to provide adequate traction for safe steering under good conditions. Slow down on hills, rough terrain, and curves.
Front and rear, and left and right are determined by the normal direction of travel (the same as on your automobile).
SX15 01/09 | Introduction Section |
© 2009 Alamo Group Inc.