ASSEMBLY
3.Install Tongue (#1) pivot tubes into clevis type openings at front of Center Section. Insert Pivot Pin (#2) through outside clevis flat, pivot tube, and then inside clevis flat. Rotate head of pin so that the hole on the head of the pin lines up with the hole on the outside clevis. Insert 1/2 x
4.Install Center Axle Legs (#1or #2) and Outer Axle (#16) to Center Axle (#2) using 3/4" x 4" bolts (#18), and lock nuts (#7). Tighten securely. NOTE: Install bolts through flats on Axle tube (#6) and through gauge wheel Axle Legs (#1or #5) and then Center Axle (#2). Attach the adjustment Turnbuckle to the Outer Axle (#6) and Wing Axle using flatwashers (#10) and cotter pins (#8). Attach the Wing Axle Legs (#5) to the Wing Axle (#11) 3/4 x
SX15 01/09 | Assembly Section |
© 2009 Alamo Group Inc.
