
ASSEMBLY
ASSEMBLY
5.Install Main Driveline. Attach Driveline Yoke to Mower Divider Gearbox. Tighten Clamping Cone Yoke to 75
6.Attach Slip Clutch end of Wing Driveline to shaft on Divider Gearbox . Insert clamp bolts or clamping cone depending on driveline type and tighten securely (75
Many of the equipment components are HEAVY (60 lbs or greater) and Special Lifting Procedures are recommended. Use lifting assistance such as mechanical assistance, two people, and proper lifting techniques when connecting or installing the driveshaft to reduce the possibility of back injuries
7.Install Center Divider Gearbox Shield. Remove the top two bolts and lockwashers from the Center Gearbox. Install the shield on the Center Divider Gearbox and replace with longer hardware.
8.Install opposite end of Wing Driveline to outer Gearbox input shaft. Secure yoke on shaft by tightening taper pin to 75 ft/lbs. located on Driveline Clamp. NOTE: To facilitate removal of Clutches and Yokes from splined shafts in the future, it would help to place a small amount of lubricating grease on the splines before installation.
SX15 01/09 | Assembly Section |
© 2009 Alamo Group Inc.