ASSEMBLY
ASSEMBLY
CHECK CHAINS (EXTRA EQUIPMENT) FOR LIFT MODELS
Check Chains are available for attachment to the front of the cutter as an accessory. Check chains are used to control the cutting height and especially to allow the cutter to be lowered to the same preset cutting height effortlessly.
Install lower end of check chain (4) to hitch ears (6) through hole (7) [see HOLE NOTE below] using bolts (8), lockwashers (9) and nuts (10). Tighten securely.
Install chain lugs (3) on either side of tractor top link mounting (5) using bolt or pin (2) of required diameter and length. Cat I kit requires a 3/4" diameter bolt. Cat II kit requires a 1" diameter bolt. Install top end of check chains in brackets (3).
Cutting height is then set by placing proper chain link in keyhole slot. Cutting height is easily adjustable by hooking chain higher or lower in the keyholes in chain lug (3).
For additional safety in transport, raise mower as high as possible without having driveline hit deck and shorten check chains as much as possible to prevent inadvertent falling in transport.
TW84 03/07 | Assembly Section |
© 2007 Alamo Group Inc.
