Alamo TW84 manual Connecting the Mower-Lift Type

OPERATION

Always shut the Tractor completely down, place the transmission in park, and set the parking brake before you or anyone else attempts to connect or disconnect the Implement

and Tractor hitches. (S3PT-15)

6.1 Connecting the Mower-Lift Type

1.Make sure the tractor is equipped with the correct PTO shaft. Change shafts if needed..

2.Shorten or remove the tractor drawbar to avoid interference when raising and lowering the mower.

3.Board the tractor and start the engine. Posi- tion the tractor to the mower with the 3-point lift arms positioned between the respective set of mower A-frame lift lugs. Note: Set the 3-point lift control to “Position Control” so that the lift arms maintain a constant height when attaching the mower. See the tractor Opera- tor’s Manual for correct settings when attach- ing 3-point equipment.

4.Turn off the tractor engine and dismount.

5.One lift arm at a time, align arm end hole between the set of holes of A-frame lift lugs. Insert hitch pin through the lug and arm holes and insert retaining pin into hitch pin.

6.Walk around to opposite side and repeat pro- cedure for remaining lift arm and hitch pin.

7.Extend or retract 3-point top link to align its end hole with the holes of the mower’s top link. Insert the top link hitch pin and insert retaining pin into hitch pin.

8.Adjust any lower link check chains, guide blocks, or sway blocks to prevent the mower from swaying side to side and possible con- tact with tractor rear tires.

TW84 03/07 Operation Section 4-11

© 2007 Alamo Group Inc.

OPERATION