ASSEMBLY
JACKSHAFT BEARING SUPPORT ASSEMBLY (FIGURE -PULL TYPE)
Attach the Jackshaft bearing support bracket (1) to the tongue. Loosely attach bearing support by using pivot bolt (3) with bushing (6).Be sure that bearing supports are essential through the front hole closest to clevis on the tongue. Install Bearing and housing assembly (4). Install spacers (5) and bolt (2) leaving installed loosely. Tighten bolt (2) NOTE: Do not tighten to point of collapsing spacer (5). Tighten pivot bolt (3) NOTE: Do not over tighten. Make sure Carrier Bearing (4) pivots in supports and complete assembly pivots on lower bolt. Slide Jackshaft through bearing (4) slide spacer (7) on Jackshaft (NOTE: Spacer goes between bearing and Quick Disconnect Yoke.) See parts pages for Jackshaft Bearing Support prior to Serial # 10705
NOTE: ALL Yokes must be set as shown for proper phasing.
TW84 03/07 | Assembly Section |
© 2007 Alamo Group Inc.