OPERATION
Operating Position
To lower the mower, retract the hydraulic cylinders to remove tension from the transport locks. Then pull the release rope and place the hydraulic control lever in the float detent to lower the mower.
The mower must be operated with the cutter sections fully lowered and the hydraulic control lever in the float detent to ensure the mower follows the contour of the ground and to prevent sections from creeping up. NEVER attempt to raise the mower while the mower is operating.
10.4 Operating the Tractor and Mower
Start off by operating at a slow speed and gradually increase your speed while maintaining complete control of the tractor and mower. Moving slowly at first will also prevent the tractor from rearing up and loss of steering control. The tractor should never be operated at speeds that cannot be safely handled or which will prevent the operator from stopping quickly during an emergency. If the power steering or engine ceases operating, stop the tractor immediately as the tractor will be difficult to control.
Drive the tractor with the
Perform turns with the tractor and mower at slow speeds to determine how the tractor with an attached mower handles a turn. Determine the speed to maintain proper control of the tractor when making turns. When turning with a towed implement, the overall working length of the unit is increased. Allow additional clearance for the mower when turning.
To avoid overturns, drive the tractor with care and at safe speeds, especially when operating over rough ground, crossing ditches or slopes, and turning corners. Tractor wheel tread spacing should be increased when working on inclines or rough ground to reduce the possibility of tipping.
Use extreme caution when operating on steep slopes. Keep the tractor in a low gear when going downhill. DO NOT coast or
TX235 02/07 | Operation Section |
© 2007 Alamo Group Inc.
OPERATION
