ASSEMBLY
DRIVELINE ATTACHMENT
Before starting assembly, make certain that all paint, dirt and grease are removed from gearbox shaft (1). To ease assembly, apply a light coat of grease to splines and assemble. Do not assemble a driveline without a shield.
Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque. Refer to Torque Chart in Maintenance Section.
JACKSTAND AND HOSE ATTACHMENT
All drivelines are equipped with slide collar on end yokes. To attach to the shaft grab and pull the collar on the end of attaching yoke toward the opposite end of the driveline. Slide the yoke (with collar depressed) onto the shaft. Move the yoke back and forth until the collar clicks forward and locks yoke in place.
Install the Jackshaft (1) on the Front Gearbox and install Bearing (2) on the Drive End. Sandwich the Bearing between the Bearing Supports (3 & 7). Install the Pipe Spacers (4) and retain with 1/2” x 7” bolt (5) and locknut.
TX235 02/07 | Assembly Section |
© 2007 Alamo Group Inc.
ASSEMBLY
