
ASSEMBLY
CASTER WHEEL ATTACHMENTS - REAR MOWER
Attach the right and left Axle Arm Weldment (1) to the deck with bolts (2) flatwasher (3), and locknuts
(4). Install two flanges (5), two1/4 inch spacer (6) and three one inch spacers (7) on each fork and wheel assembly shaft (8). Insert fork shaft (8) into axle arm weldment (1). Install two additional 1/4 inch spacers (6) on each axle shaft (8) and retain using Snapper Pin (9).
NOTE: Caster Wheel Mounting Beams Item #1 may be shipped attached to deck.
CASTER WHEEL ATTACHMENTS - WING MOWER
Attach the right and left Axle Arm Weldment (1) to the deck with bolts (2) flatwasher (3), and locknuts
(4). Install two flanges (5), two1/4 inch spacer (6) and four one inch spacers (7) on each fork and wheel assembly shaft (8). Insert fork shaft (8) into axle arm weldment (1). Install two additional 1/4 inch spacers (6) on each axle shaft (8) and retain using Snapper Pin (9).
NOTE: Axle arm toward center of machine must have bracket attached so that transport bar maybe installed as show. When minimun transport width is desired always raise and lock bar in vertical position.
TX235 02/07 | Assembly Section |
© 2007 Alamo Group Inc.
ASSEMBLY