TABLE OF CONTENTS |
|
1. FCC STATEMENT | 1 |
2. SAFETY INSTRUCTIONS | 2 |
3. README FIRST | 4 |
4. WITHOUT VISION CONVERTER | 6 |
5. | 7 |
6. | 8 |
7. INSTALLATION | 9 |
8. USING THE MONITOR | 12 |
9. Using the Remote Control | 14 |
10. ACCESSING THE MAIN MENU | 18 |
11. ENERGY SAVING | 22 |
12. REAR | 23 |
13. REAR | 24 |
14. SIMPLE TROUBLE SHOOTING TIPS | 25 |
15. | 26 |
16. | 27 |
17. VGA CONNECTOR ASSIGNMENT | 28 |
18. | 29 |
19. FACTORY PRESET AND COMPATIBLE MODE | 30 |
20. IR REMOTE CONTROLLER CODE | 31 |
21. DM RS232 QUICK INSTALLATION | 32 |
1. FCC STATEMENT
This equipment has been tested and found to comply within regulations for a Class B digital device, pursuant to Part 15 of the FCC rules. These regulations are designed to provide protection against harmful interference in a residential installation. This equipment can generate, use and radiate radio frequency energy, and if not installed and∕or used in accordance with the instructions
provided, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures：
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•Consult the dealer or an experienced radio∕TV technician for assistance.
Warning：
Only use shielded cable to connect I/O devices to this equipment.
Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate this equipment.
0 | 1 |
