Alliance Laundry Systems 9001889R7 manual Version of Control, Program Storing Mode

Version of Control

To determine control version, apply power to machine. Control will display version of control (i.e., 1.15).

Language on Display (Version 1.15 and later ONLY)

To set a different language on the WE-8 display:

1.Turn key from RUN to PROGRAM.

2.Press “Auxiliary”, “2” and “9” to enter set-up mode.

3.English will display. Press “Advance” until desired language displays (French, Italian, Spanish and German).

4.Press “Enter” keypad.

5.Press “Enter” to advance through set-up mode.

6.Wait until information is saved.

7.Turn key from PROGRAM to RUN.

8.Display will read language chosen for all cycles.

Setup of the Chemical Hold Feature (Version 1.11 and later ONLY)

∙At power up, verify that model is at least version 1.11. Refer to version of Control Section. Earlier versions do not have this chemical hold feature.

∙Insert key into key switch and turn to Program.

∙Push the Auxiliary key, the 2 key, and the 9 key in succession to enter System Program Mode.

∙Push the Start key 10 times to arrive at the Chemical hold choice.

∙Push the Add Cycle/Advance key to toggle the Chemical hold feature either Yes (on) or No (off).

∙Push the Start key twice to save changes and exit System Program Mode.

∙Turn key switch to Run.

NOTE: If chemical hold is on, then a switch closure/opening between pins 1 and 4 of the COIN header on the output board will control supplies 4 through 9. A closure will turn the programmed supply/ies on and count down the time for the supply to be on. An opening will turn the programmed supply/ies off and halt the time for the supply to be on.

Programming

NOTE: If chemical hold is off, then supplies 4 through 9 are controlled exactly like supplies 1 through 3. A switch closure/opening between pins 1 and 4 of the COIN header on the output board will have no effect.

Program Storing Mode

The WE-8 control is capable of 99 total cycles. One cycle contains 1 or more steps.

One step is a function of the wash program (example: heat).

Choose between the following functions:

Fill:	To fill the machine with water.
Wash:	Wash action of the machine.
Supply:	To add detergent to the wash (liquid or
	powder).
Cooldown: Cool to programmed temperature
Heat:	To heat the water.
Soak:	The wash will be soaked for a
	programmed time and a programmed
	temperature.
Aux:	A relay contact will close for a
	programmed time.
Spin:	To spin the machine for a programmed
	time and RPM.
Drain:	To drain the water from the machine.

9001889 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 7