Electrical Installation Requirements
IMPORTANT: Electrical ratings are subject to change. Refer to serial decal for electrical ratings information specific to your machine.
DANGER
Hazardous Voltage. Will cause shock, burn or death. Allow machine power to remain off for three minutes prior to working in and around AC inverter drive.
W735
WARNING
Dangerous voltages are present inside the machine. Only qualified personnel should attempt adjustments and troubleshooting. Disconnect power from the machine before removing any cover and guards, and before attempting any service procedures.
W736
WARNING
Hazardous Voltage. Can cause shock, burn or death. Verify that a ground wire from a proven earth ground is connected to the lug near the input power block on this machine.
W360
Electrical connections are made at the rear of the machine. The machine must be connected to the proper electrical supply shown on the identification plate attached to the rear of the machine, using copper conductors only.
IMPORTANT: Alliance Laundry Systems warranty does not cover components that fail as a result of improper input voltage.
Installation
Make sure the correct transformer jumper (208 Volt or 240 Volt) is in place. Refer to the “optional” Electrical Service Connection label located on the back of the machine near the electrical service input for machine electrical requirements. Refer to Figure 26.
1
CHM2287N
1Electrical Service Connection Label
Figure 26
Machines equipped with an AC inverter drive require a clean power supply, free from voltage spikes and surges. Use voltage monitor to check incoming power. The customer’s local power company may provide such a monitor.
F8208301 | © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT | 43 |
