Installation

CAUTION

Do not attempt to increase fuse rating or alter wiring of external chemical supply terminal strip in such as way that may conflict with the suggested methods provided on the Optional External Supply Wiring Diagram.

W699

Connection of External Liquid Supplies

20 – 80 Pound OPL Models

1.Facing the rear of the machine, locate the five 3/8 inch supply hose connections found on the right-hand side of the valve panel. Refer to Figure 29.

 

20-80 Pound Models

 

 

C VALVE PANEL – REAR VIEW

1

 

CHM2237N

 

 

CHM2237N

1

External Supply Hose Opening

 

Figure 29

2.Drill through the five plastic holes on the valve panel for the external supply hoses as needed.

3.Remove plastic debris.

4.Attach the external supply hoses to the ports at each of the drilled holes.

5.Secure with proper clamps.

NOTE: Do not attempt to make chemical injection supply pump electrical connections to points other than those provided specifically for that purpose by the factory.

Consult the supply vendor instructions for operational details about supply injections.

125 Pound OPL Models

(With Optional Dispenser)

Refer to Figure 30.

1.Remove plugs from base. Plugs are assembled inside tubing ring.

2.Install strain reliefs with the seal nuts.

3.Insert tubes through base. Do not remove dry supply cups. Tube should extend into plastic cup, with exception of softener tube, which should be routed to outside of cup.

4.Tighten seal nut to prevent tubing from escaping assembly.

IMPORTANT: Increasing fuse rating may cause damage to washer-extractor’s circuitry.

IMPORTANT: Any injection system pump that requires anything other than 24VAC must be powered by a separate external power source.

Consult chemical injection supply system instructions for operational details.

1

2

3

4

5

PHM2001N

CHM2001N

1Strain Relief for Liquid Chemical Supply Lines

2Supply Dispenser Lid

3Four Way Water Valve

4Dry Supply Cups

5Supply Dispenser

Figure 30

54

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F8208301

Page 56
Image 56
Alliance Laundry Systems CHM1772C manual Connection of External Liquid Supplies, 20 80 Pound OPL Models