Specifications and Dimensions

To connect water service to machine with rubber hoses, use the following procedure:

1.Before installing hoses, flush the water system for at least two minutes.

2.Check filters in the washer-extractor’s inlet hoses for proper fit and cleanliness before connecting.

3.Hang the hoses in a large loop; do not allow them to kink.

If additional hose lengths are needed, use flexible hoses with screen filters. Each hose should have a screen filter installed to keep rust and other foreign particles out of the water inlet valves.

Pressure of 30 – 85 psi (2 – 5.7 bar) provides best performance. Although the washer-extractor will function properly at lower pressures, increased fill times will occur.

Suitable air cushions should be installed in supply lines to prevent “hammering.” Refer to Figure 16.

For machines labeled with the CE mark, backsiphon protection devices must be installed previous of all machine water inlet valves in accordance with accepted European standards.

1

2

P038I

P038I

1Air Cushions (Risers)

2Water Supply Faucets

Figure 16

UWPV Pocket Hardmount

Water Supply Line Sizing

Model

Number

Supply Line Size, in (mm)

 

 

 

of Machines

Main

Hot/Cold

 

 

 

 

 

 

 

1

1 (25)

0.75 (19)

35

2

1.5 (38)

1 (25)

3

2 (50)

1.25 (32)

 

 

4

2 (50)

1.5 (38)

 

1

1.25 (32)

1 (25)

60

2

2 (50)

1.25 (32)

3

2 (50)

1.5 (38)

 

 

4

2.5 (64)

2 (50)

 

1

1.25 (32)

1 (25)

80

2

2 (50)

1.25 (32)

3

2 (50)

1.5 (38)

 

 

4

2.5 (64)

2 (50)

 

1

1.5 (38)

1 (25)

100

2

2 (50)

1.5 (38)

3

2 (50)

1.5 (38)

 

 

4

2.5 (64)

2 (50)

 

1

2 (50)

1.25 (32)

125

2

2.5 (64)

2 (50)

3

2.5 (64)

2 (50)

 

 

4

2.5 (64)

2.5 (64)

 

1

2 (50)

1.25 (32)

150

2

2.5 (64)

2 (50)

3

2.5 (64)

2 (50)

 

 

4

2.5 (64)

2.5 (64)

 

 

Table 6

 

30

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

F232084