Chapter 3: Cabling the Network Ports
Powering on a Switch
To power on a switch, perform the following procedure:
1.Position the power cord retaining clip in the up position, as shown in Figure 28.
100- |
|
240VAC | ~ |
|
Figure 28. Power Cord Retaining Clip in the Up Position
2.Plug the power cord into the AC power connector on the back panel of the unit (see Figure 29).
Warning: Power cord is used as a disconnection device. To de- energize equipment, disconnect the power cord. E3
100- |
|
240VAC | ~ |
|
Figure 29. Connecting the AC Power Cord
3.Connect the other end of the power cord to an appropriate AC power outlet. For power specifications for the switch, refer to “Power Specifications” on page 66.
52
