Alpha Tool.Com.HK Limited VSP-230 SPLASH GUARD INSTALLATION

1 36

SPLASH GUARD INSTALLATION

CAUTION!

The splash guard should be used to prevent the water and

dust from going inside the tool. Failure to do so can shorten

the life of your tool and void the limited warranty.

1. Install the rubber splash guard into

the tool so that the lip on the splash

guard ﬁ ts into the groove on the tool

and the cutout is around the water

ﬁ tting.

2. Open the band clamp completely

and wrap around the splash guard

under the water ﬁ tting.

3. Tighten the clamp until snug.

Groove

Figure-18

Figure-19

Figure-20

Contents

Main TABLE OF CONTENTS VSP-230 OVERVIEW SPECIFICATIONS Page INTRODUCTION ABOUT THE SYMBOLS CAUTION! GENERAL SAFETY RULES WORK AREA ELECTRICAL SAFETY PERSONAL SAFETY SERVICE SPECIFIC SAFETY RULES USE PROPER EXTENSION CORDS GROUNDING INSTRUCTIONS ADDITIONAL PRECAUTIONS FOR USING THE VSP-230 DANGER! WARNING! LAWS AND REGULATIONS OF NOISE LEVELS VSP-230 VARIABLE SPEED WET POLISHER OPERATION CAUTION! MAIN CONNECTION SWITCHING ON AND OFF Switching on: DANGER! CAUTION! DANGER! WARNING! CAUTION! TESTING IN-LINE GFCI UNIT VARIABLE SPEED ADJUSTMENT SPEED POT FEEDBACK SENSOR WATER CONTROL VALVE SIDE HANDLE INSTALLATION Page SPLASH GUARD INSTALLATION PROFILER AND OTHER APPROVED SPINDLE ATTACHMENTS WATER-FEED ATTACHMENT MAINTENANCE DAILY PERIODIC BEARINGS AND GEARS CARBON BRUSH REPLACEMENT REAR COVER REMOVAL Page Page Page Page Page ALPHA VSP-230 PARTS LIST ALPHA VSP-230 PARTS LIST SERVICES AND WARRANTY INFORMATION LOANER PROGRAM NEED MORE INFORMA TION ALPHA VSP-230 PARTS LIST Suite #5 EC DECLARATION OF CONFORMITY APPENDIX A FREQUENTLY ASKED QUESTIONS HELPFUL HINTS PRODUCT REGISTRATION CARD