Introduction, About the Symbols | Alpha Tool.Com.HK Limited VSP-230

INTRODUCTION

Thank you for purchasing the Alpha® Wet Polisher. Please read this instruction manual thoroughly to ensure safety and correct use of the polisher. Keep this manual in a place where operators can access it easily whenever necessary.

ABOUT THE SYMBOLS

According to the hazard level, all safety notes in this manual are classiﬁed into “DANGER”,

“WARNING”, and “CAUTION”.

DANGER!	Death or serious personal injury is imminent when handling this
	polisher incorrectly.
WARNING!	There is a possibility of death or serious personal injury when
	handling this polisher incorrectly.
CAUTION!	There is a possibility of personal injury or property damage when
	handling this polisher incorrectly.

NOTE: In some situations, failing to observe WARNING notes could result in death or serious personal injury. Be sure to read and observe the safety notes to ensure safety and correct use of the polisher.

ELECTRICAL SYMBOLS

The following show the symbols used for tool.

V	Volts
A	Amperes
Hz	Hertz
~ or a.c.	Alternating Current
n0	No load speed
…/min	Revolution or reciprocation per minute
kg	Kilograms
	Protective Earth

5

Image 5

Alpha Tool.Com.HK Limited VSP-230 instruction manual Introduction, About the Symbols

Contents

Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview Specifications Components Accessories Introduction About the Symbols Electrical Safety General Safety RulesPersonal Safety Work Area Tool USE and Care Service Specific Safety Rules Grounding Instructions USE Proper Extension Cords Check the working voltage Additional Precautions for Using the VSP-230 Laws and Regulations of Noise Levels Be careful of your surroundings when working in high places Main Connection Switching on and OFFVSP-230 Variable Speed WET Polisher Operation Gfci Information Ground Fault Circuit Interrupter Gfci Testing IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed Adjustment Water Control Valve Speed POT Feedback Sensor Side Handle Installation Recommended Heights Customizing the Splash Guard Splash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle Attachments Periodic MaintenanceDaily Bearings and Gears Carbon Brush Replacement Rear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts List Ring Need More Information Services and Warranty Information Loaner Program Warranty Alpha Tool Repair Service EC Declaration of Conformity Appendix a Frequently Asked Questions Helpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax