Alpha Tool.Com.HK Limited VSP-230 specs

5.Pull the valve assembly away from mount.

6.Remove the rear case screw.

7.Hold polisher with one hand and pull the rear case straight back with the other hand.

NOTE: Do not twist case in a side to side motion when pulling back.

8.Pull back the rear case until the carbon brush assembly is exposed.

NOTE: Do not pull rear case further back from this point.

Figure-28

Figure-29

Figure-30

Figure-31

23

Image 23

Alpha Tool.Com.HK Limited VSP-230 instruction manual

Contents

Alpha Variable Speed Wet Polisher Table of Contents VSP-230 Overview Specifications Components Accessories Introduction About the Symbols Work Area General Safety RulesElectrical Safety Personal Safety Tool USE and Care Service Specific Safety Rules Grounding Instructions USE Proper Extension Cords Check the working voltage Additional Precautions for Using the VSP-230 Laws and Regulations of Noise Levels Be careful of your surroundings when working in high places Main Connection Switching on and OFFVSP-230 Variable Speed WET Polisher Operation Gfci Information Ground Fault Circuit Interrupter Gfci Testing IN-LINE Gfci Unit Before Each Use Of The Polisher Variable Speed Adjustment Water Control Valve Speed POT Feedback Sensor Side Handle Installation Recommended Heights Customizing the Splash Guard Splash Guard Installation WATER-FEED Attachment Profiler and Other Approved Spindle Attachments Periodic MaintenanceDaily Bearings and Gears Carbon Brush Replacement Rear Cover Removal Page Spade Connector New Carbon Brush Clean Dirty Alpha VSP-230 Schematic Drawing no Description Quantity Alpha VSP-230 Parts List Ring Need More Information Services and Warranty Information Loaner Program Warranty Alpha Tool Repair Service EC Declaration of Conformity Appendix a Frequently Asked Questions Helpful Hints Product Registration Card Bauer Drive, Oakland, NJ 07436 800-648-7229 Fax