19
PROFILER AND OTHER APPROVED SPINDLE ATTACHMENTS
CAUTION!
Do not leave threaded accessories on the spindle of the tool for extended periods of time,
as this may result in making it diffi cult to remove these accessories.
The VSP-230 polisher has a M14-2 center water-feed spindle thread.
To attach a profi ler wheel or other ap-
proved spindle attachments, follow the
steps below:
1. Screw the attachment onto the
spindle by hand.
2. Tighten with supplied wrench.
NOTE : If attachment does not thread on
freely, check threads on both sur-
faces for damage or dirt. Clean,
repair or replace as needed to
ensure a safe and tight connec-
tion to the polisher.
WATER-FEED ATTACHMENT
Attach the polisher water-line fi tting to any garden hose connection.
OPERATION
WARNING!
To reduce the risk of electric shock, check the tool’s water supply system to ensure there is
no damage to the seals or hoses. A damaged water supply system may result in abnormal
water fl ow to the tool which could be dangerous.
Figure-21
Figure-22