Basic Operation
POWER RESET
c ANGLE 89
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first time, after installing the CD changer, etc., or after changing the car battery.
1 Make sure that the power of the unit is off. If the power is on, press and hold the POWER button for at least 3 seconds to turn off the unit.
2 Press the RESET switch with a
RESET
Opening the Front Panel
1 Press the Open button on the Front Panel.
Open Button
NOTE
The display will close a half minute after the ignition key is turned to the OFF position.
Hiding the Front Panel
1 Press and hold the c button on the Front Panel for at
least 3 seconds.
NOTES
•The Front Panel will stop moving if there is an obstacle inside the compartment. In that case, remove the obstacle and press and hold the c button again for at least 3 seconds.
•The display will close shortly after the ignition key is turned to the OFF position.
Turning Power On and Off
1 Press the POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except the eject c button, Rotary encoder and CLK button
The volume level gradually increases to the previous level you were listening to before the unit was turned off. Press and hold the POWER button for at least 3 seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level 12.
Display Angle Adjustment
Movable display
The movable display may be adjusted to 3 different angles depending upon user preference.
1 Press the ANGLE 89 button to adjust the angle of the movable display.
NOTES
•The display will close a half minute after the ignition key is turned to the OFF position.
•The adjusted angle of the display is stored in memory. There is no need to
CAUTION
Keep hands (or any other object) away from the display while it is opening or closing to avoid damage or injury. The back of the movable display will get very warm under normal operating conditions. This is not a malfunction. Do not touch.